Two-Port Building Automation Gateway
What do you need help with?
What is the default addressing schema for the EtherNet IP DCSNet(2) Slave interface?
When using the DCSNet(2) firmware in a slave configuration the addresses use the following layout:Drop 0 = N100:0 - N100:63Drop 1 = N101:0 - N101:63Drop 2 = N102:0 - N102:63etc....The first 32
Read moreWhen operating as a DCSNet(2) slave can the AN-X-AMX gateway be configured to emulate more than 1 drop area?
When operating as a DCSNet(2) slave can the AN-X-AMX gateway be configured to emulate more than 1 drop area?
Read moreWhat do the jumpers do on the PLX3x gateways?
. To place the gateway into Mode 2 follow these steps: 1) Power down the gateway 2) Place the jumper in mode 2 (horizontally on the middle pins) 3) Power up the gateway At this point the gateway will use
Read moreWhy am I getting: Download was successful but Module failed to reboot in 60 seconds
. If we don't have a backplane connection, this will result in the "download was sucessful but module failed to reboot" error. Common causes include: 1) Your Compact Logix is not in run mode. 2) Your
Read moreDoes the AN-X(2)-AB-DHRIO gateway running the RIO HMI firmware support multiple block transfers to the same Rack, Group, and Slot?
4)Rack,0o02,1,4 ; define rack at octal 02, start quarter 1, and quarter 4; Allows multiple BTRs and BTWs to occur to the same Rack, Group, and Slot.BtByLenbtW,0o02,0,0,7, 0,64, ; define btw, rack 02
Read more