Two-Port Building Automation Gateway
What do you need help with?
Why can't I download my program to an L3 series controller on Revision 20?
, as shown here at the bottom of page 11: Revision 21 Change Notes Update: February 2016 - Rockwell has released a new Revision 20 series firmware, 20.018, that also fixes the issue for version 20 users.
Read moreCROB functions in serial DNP modules
Example of using a conditional CROB to control BO 3 in slave 2 to using "Latch on" and Latch off" commands. Node address (of the slave) is 2. Object 12 Variation 1 Function 5 (Direct Operate
Read moreI just powered up my ICX30-HWC, how do I access it?
address of the ICX30 to load up the default login page. Login with the default credentials of ADMIN and PASSWORD, and you are ready to configure your ICX30!
Read moreMy Wireless Inputs/Outputs aren’t working properly
are on the same digit on their dial. For example, I sent me Analog card to "1", make sure its pair is also set to "1" Make sure that you jumper the input/output with the COM on the card.
Read moreHow many Data Highway Plus Nodes can a single AN-X2-AB-DHRIO communicate with?
of the delays will vary depending on your network, our rule of thumb for time sensitive applications is to use no more then 1 EtherNet/IP device and 4 DH+ devices per AN-X2.
Read more