- Solutions
- Productos
- SERVICIOS Y SOPORTE
-
NOVEDADES Y EVENTOS
- ProSoft Insights (Blog)
-
Podcast
Knowledge Base / Protocols / Modbus Plus
Cable hardware requirements for Modbus Plus networking.
Search KB
Categories
- 14. octubre 2016
The Modbus Plus specification states that the following Modicon parts are to be used when wiring a Modbus plus network.
AS-MBKT-085: This connector is used for inline Modbus Plus device connections. If your ProSoft of ProLinx module is going to be a drop in the middle of a Modbus Plus network, then use this Modicon connector.
MBKT-185: This connector is used for end point Modbus Plus device connections. If your ProSoft or ProLinx module is going to be at the end of your Modbus Plus network, then use this Modicon connector.
490NAA271XX: This is the Modicon part number for the cable required for a Modbus Plus network. The last two digits depend on the distance requirements of your network.
- 100 feet - 01
- 500 feet - 02
- 1000 feet - 03
- 1500 feet - 04
- 2000 feet - 06
A standard DB9-M type serial connector cannot be used in a Modbus Plus network.
Attachments
Related Products