Two-Port Building Automation Gateway
What do you need help with?
The order of bits in the Binary Inputs and Outputs of my PTQ-DNP module appear to be the opposite of what I expect. Why?
. In other words, to set DNP BI point 0, you have to set bit 15 in the 4X Holding Register and when you want to set DNP BI point 15, you have to set 4X Holding Register bit 0, and all the other bit positions
Read moreThe BATT LED on my ProSoft MVI module is RED. How can I fix this problem?
. If the module has been left in an unpowered state for more than 2-4 weeks, the BATT LED may come on when the module is first powered up. If left in a powered-up chassis, the on-board battery will recharge
Read moreWhen configuring Siemens ET200M slave (possible other complex PROFIBUS slaves), 1. PDPM master failed to read PT100 AI inputs. 2. Sycon software failed to configure slave parameters, error messages we
"error reading user param data!" ProLinx PROFIBUS DPV0 master all PDPM SYCON EDT200M revision 4, 5 and 6000 series v2.65 and earlier 1. it was necessary to upgrade PROFIBUS master configuration
Read moreHow do I increase my ReadData array for an MVI56-MCM module?
. For 2000 words of readdata we will need this to be between 1 and 10.The module pages data in blocks of 200 words. The first block has a block index of 1, and contains the first 200 words of data from
Read moreI upgraded my RSLogix5000 software from an older version to Version 16 and now the clock in my MVI56 module does not seem to show the correct time. Why not?
product web page for your specific module or contact ProSoft Technical Support for assistance.
Read more