Two-Port Building Automation Gateway
What do you need help with?
What Ethernet ports are required for Prosoft PLC modules and gateways?
for products including AN-X2 and Fieldserver gateways require TCP port 80 Some of the more common ports required for application protocols are: TCP 502 Modbus TCP - MBTCP, MNET products TCP 44818 Ethernet
Read moreWhat are the differences between the DCSNet and DCSNet2 firmware?
The major difference between these 2 firmware revisions is how much data the AN-X-AMX unit can transfer to a CompactLogix or ControlLogix processor: DCSNet firmware supports emulating a single ... DCSNET, dcsnet, DCSNet2, dcsnet2, ... What are the differences between the DCSNet and DCSNet2 firmware?
Read moreMy MVI69 module is not working. What might be wrong?
-defined datatypes, controller tags, and ladder logic. 2. The CompactLogix CPU must be in RUN mode. The module has to see the processor operating on the 1769 I/O bus before it can complete its boot routine
Read moreDo ProSoft AFC flow computer solutions support energy calculations according to the ISO-6976 standards?
that the user must perform and avoid the need for machine computation (programmed computer). On the other hand, AGA 8 lists the coefficients of a second-degree (order 2, quadratic) polynomial for Cp over
Read moreWhat is the correct function code to use when reading and writing with an MBP Modbus Plus module?
The MBP Modbus Plus modules use the modicon quantum MSTR commands. MSTR 1 is used for a write command. MSTR2 is used for a read command. The modules support the 4XXXX range addressing
Read more