Two-Port Building Automation Gateway
What do you need help with?
How can I determine what hardware BIOS is installed on my MVI94?
Please use the following procedure: 1 - Power down the MVI94. 2 - Remove it from the base. 3 - Place the Setup jumper to short both pins, as shown in the diagram on the side of the module. 4
Read moreHow to avoid slow data updates on a Modbus network with an MVI56(E)-MCM or MVI69-MCM when some Slaves are either not on-line or not functioning correctly?
command in the list. Although this is a problem that is common on any master/slave multidrop network (like Modbus, DF1, DNP, etc...), ProSoft MCM solutions have several ways that you can minimize
Read moreWhere can I locate the User Manual for the MVI46-MCM
All User Manuals for Prosoft Technology products can be found on the product pages of our website, or on the CD supplied with the product. <="" user="" mvi46-mcm="" a=""> Related Keywords
Read moreI'm trying to execute a message instruction from my ControlLogix Processor to the MVI56-BAS but I get an error on the Msg instruction
There's a compatibility issue between the RSLogix version 13 and the firmware 1.03 on the MVI56-BAS. To solve this problem you need to upgrade to the version 1.04 of the MVI56-BAS. Contact
Read moreWhat are the pin outs for the RJ-45 jack on my Prosoft MVI module?
The pins in the RJ-45 jacks on the MVI-series modules are numbered 1, 2, 3,...8, top to bottom. Pin 1 is the topmost pin in the jack, pin 8 is the bottommost pin in the jack. You can eliminate
Read more